Configure your FCS One setup based on your tank and requirements.
FCS One DC supports up to 2 CAN devices and 2 24V DC relay outputs.
The CAN ports can also be programmed as 24V outputs using an adapter (7713833).
Typical setup of FCS One is Density or temperature sensor with spunding kit and cooling actuator.
If you want more features, choose FCS.
If you have multiple tanks, set up the system and change the quantity in the cart before ordering.
Remember:
- You don't need a temperature sensor if you get the Density Sensor
- We always recommend the 300mm Density Sensor on all our tanks, including MiniUni.
- Accessories like Tees, Clamps and Adapters is found at the bottom of the page.
- If you want to regulate both gas in and out, you can not have the density sensor as the CAN port must be used as a relay output using an adapter (7713833).